Introduction to this issue: Street Washing Vehicles Tricycle Use Method

Street Washing Vehicles Tricycle Use Method is the use of gasoline engine or permanent magnet brushless DC motor to drive high pressure water pump to generate low speed high pressure water flow, and then through the high pressure pipe to the high pressure nozzle, high speed high pressure water flow, the left and right side of the vehicle and the seven hole front flushing device is used to wash the pavement and stone along the road and other small roads. In addition, the high-pressure water gun configured by the vehicle can be used to clean up small urban advertisements, wash trash cans and fruit boxes, remove ground dirt, restore the color of floor tiles, wash public facilities such as bus stops and public toilets. Street Washing Vehicles Tricycle can work together with small road sweeper, fast washing and cleaning of sidewalks and side roads, operation efficiency will be higher. The vehicle is compact in size, light in weight, strong in passability, easy to turn, and will not cause damage to pavement tiles, manhole covers and other public facilities.

The following Xiaobian to  Street Washing Vehicles Tricycle as an example to give you a detailed introduction to the use of Street Washing Vehicles Tricycle, the details are as follows:

This model is a multi-function Street Washing Vehicles Tricycle, which is mainly divided into forward flushing, left and right hedging, and side flushing. A 15-meter high-pressure pipe is installed at the rear of the vehicle, and a high-pressure hand-held water gun can be installed for flushing. The pressure can reach 280 kg.

The following is a detailed introduction to the main components and steps of multi-functional Street Washing Vehicles Tricycle .

Street Washing Vehicles Tricycle  three-way steering valve, mainly used to adjust the steering front flushing and rear hose flushing valve. When the valve handle is located below, the front flush has been drained. When the right side of the valve handle is parallel, water is flowing through the rear coil.

When the Street Washing Vehicles Tricycle replaces the front flush and the left and right side flush high pressure pipe, turn back the quick connector, remove the high pressure pipe, turn back the shrapnel when installing the high pressure pipe, install it well, and remember to turn back the dial.

Street Washing Vehicles Tricycle power switch. Water level alarm, when the refill water button is pressed, the water level is lower than the set water level, it will automatically alarm, prompting the staff to inject water into the tank. Warning light. When this button is pressed, the rear warning light will flash and play music. It is mainly used to warn pedestrians and vehicles to avoid. Lift control knob, the main control front and left hedge lifter, when the knob is down, the front lifter will move down, when the knob is up, the front lifter will move up. This function can adjust the contact height between the washers and the ground according to the different road conditions of the work site. Working mode, when the button is pressed, the working mode is opened, the vehicle driving speed is 5-8 kilometers per hour, when the button is pressed, the working mode is closed, the driving speed returns to normal speed, this function is mainly used for the vehicle driving working state, good flushing effect, can ensure the safety of staff.

Street Washing Vehicles Tricycle high pressure pump, engine, coil, ignition switch, oil tank, pressure regulating valve. The pressure has been adjusted. When the throttle switch is turned outward, the throttle is increased, and when it is pushed inward, the throttle is reduced. When the damper is pulled outward, close it; when the damper switch is pushed inward, open the carburetor main switch; when the carburetor switch is pulled outward, close the oil circuit. When the carburetor main switch is pushed inward, open the oil circuit.

When the Street Washing Vehicles Tricycle starts the engine, there must be a water outlet switch to keep smooth, start the engine, the damper is pulled outward, the key is rotated to the right, the machine is started, the damper is returned, and the throttle is increased. Turn off engine, throttle back to minimum, key to left, carburetor master switch outward.

Street Washing Vehicles Tricycle winter drain, water source valve, water filter.

The above is a detailed description of the use of Street Washing Vehicles Tricycle. If you do not understand the place, you can consult us by phone or refer to the product instruction manual by yourself.