With the continuous development of the sanitation industry, cleaning equipment is also constantly upgraded, by the original pure manual cleaning, now also gradually began to replace by equipment, such as the appearance of the sweeping car, we can now see it in the road, park, community and so on. Want to ensure the cleaning efficiency and cleaning effect of the Electric Ride-on Sweeper, it is necessary to master the correct use of the method.

The use steps of the Electric Ride-on Sweeper are as follows:

1. The operator shall check whether the main brush, side brush, shell, power plug and other components are in good condition.

2. Fill the water tank with water before work. After working in winter, the tank should be emptied in time.

3. The operator enters the driver's seat of the machine.

4. Confirm that the gear position of the gear shifter is in the stop position and that each switch is in the off state.

5. Turn on the key switch to switch on the power supply.

6. Press the main brush (operation) switch to ensure the normal operation of the main brush and fan.

7. Press the side brush switch to make the side brush work normally.

8, flip the main brush lifting switch, make the main brush contact with the ground, in the working state.

9, flip the side brush lifting switch, make the side brush contact with the ground, in the working state.

10, gently step the Electric Ride-on Sweeper accelerator pedal (the big pedal on the right), let the sweeper move forward or backward, start the cleaning work; 11. In the process of sweeping the floor, the sweeping car needs to shake dust for 20-40 seconds every 15-30 minutes (open the dust switch).

12, according to different working environment and dust size, determine whether to open the spray system, which can effectively reduce the secondary dust.

13. The  Electric Ride-on Sweeper should lift the brush to the highest position when completing the operation to prevent the brush from deformation. Every switch is off. Turn off the power, pull out the key, and keep it safe.

14, parking should be parked on the flat road, can not park the sweeper on the slope.

15. After the work is completed, the vehicle shall be comprehensively cleaned.

16. When the voltage is less than or equal to 30V, it must stop working for charging. When charging, the special charger for the sweeper must be used for charging.

The use of  Electric Ride-on Sweeper can not only improve the working efficiency of cleaners, but also greatly reduce the manual labor force. However, because it is similar to the operation of a car in use, for the sake of safety, the operator should pull off the power switch key in time when leaving and keep it properly to prevent unauthorized use.